Instituto Tecnológico de Celaya Tecnológico Nacional de México
ITC Investigación ITC
Explorar publicaciones
Artículo · 2023 · Catálogo consolidado

Cavitation Detection in a Tonpilz-Type Transducer for Active SONAR Transmission System

Journal of Marine Science and Engineering

Ricardo Villalobos ORCID Tecnológico Nacional de México/Instituto Tecnológico de Celaya, Celaya 38010, Guanajuato, Mexico
Héctor López Tecnológico Nacional de México/Instituto Tecnológico de Celaya, Celaya 38010, Guanajuato, Mexico
Nimrod Vázquez ORCID Tecnológico Nacional de México/Instituto Tecnológico de Celaya, Celaya 38010, Guanajuato, Mexico
Roberto V. Carrillo-Serrano ORCID Faculty of Engineering, Universidad Autónoma de Querétaro, Juriquilla 76010, Querétaro, Mexico
Alejandro Espinosa-Calderón ORCID Tecnológico Nacional de México/Regional Center for Optimization and Development of Equipment, Celaya 38020, Guanajuato, Mexico

Resumen

The active sound navigation and ranging (SONAR) transmission system emits acoustic pulses underwater using a wave generator, a SONAR power amplifier (SPA), and a projector. The acoustic pulse travel in the direction of the target and return as an echo to a hydrophone to learn the range or speed of the object. Often the same device is used as a hydrophone and a projector; in this context, it is known as a transducer. In order to obtain a maximum range of detection in the SONAR, it is desirable to generate the maximum amount of acoustic power until the point in which the echo can be detectable in an atmosphere with non-wished noise. Therefore, a high value of source level (SL) is required that depends largely on the value of electrical power applied to the transducer (Pe). However, when trying to obtain the maximum range of detection in the SONAR system there are the following three peculiar limitations that affect performance: The cavitation, the reverberation, and the effect of interaction in the near field. In this paper, an experimental measurement methodology is presented to detect the cavitation effects in a tonpilz-type transducer for an active SONAR transmission system using a transducer as a projector and a calibrated hydrophone in a hydroacoustic tank by measuring the parameters of total harmonic distortion of the fundamental waveform (THD-F) of the generated acoustic pulse, transmitting voltage response (TVR) to characterize the system and sound pressure level (SPL) that indicates the intensity of sound at a given distance. Whereas the reverberation and the interaction effect in the near field are objects of other study cases. A 570.21 W and THD-F < 5% switched-mode power amplifier (SMPA) prototype was developed to excite the electroacoustic transducer employing a full-bridge inverter (FBI) topology and a digital controller using a field-programmable gate array (FPGA) for unipolar sine pulse width modulation (SPWM) to generate a continuous wave (CW) acoustic pulse at a frequency 11.6 kHz. The results obtained show that from the level of Pe=196.05 W with the transducer at 1 m of depth, the value of THD-F increases significantly while the behavior of the TVR and SPL parameters is affected since it is not as expected and is attributed when cavitation occurs.

Datos de publicación

Cita esta publicación

Comprueba el estilo que requiere tu institución o revista.

Ricardo Villalobos; Héctor López; Nimrod Vázquez; Roberto V. Carrillo-Serrano; Alejandro Espinosa-Calderón. (2023). Cavitation Detection in a Tonpilz-Type Transducer for Active SONAR Transmission System. Journal of Marine Science and Engineering, 11(7), 1279. https://doi.org/10.3390/jmse11071279

Fuentes y trazabilidad

Se conserva la procedencia de los datos y se da prioridad a la revista cuando existe información editorial.

Licencias declaradas por las fuentes

https://creativecommons.org/licenses/by/4.0/

Descargar ficha bibliográfica

El PDF contiene los metadatos y el enlace al trabajo original.