Instituto Tecnológico de Celaya Tecnológico Nacional de México
ITC Investigación ITC
Explorar publicaciones
Artículo · 2021 · Catálogo consolidado

On the Influence of Tribological Properties of AISI 4140 Annealed Steel against Ceramic Counterparts under Dry and Lubricated Conditions and Their Effect on Steel Microstructure

Metals

Luis D. Aguilera-Camacho ORCID Department of Mechanical Engineering, National Technology of Mexico in Celaya (TecNM), Celaya 38010, Mexico
María T. Hernández-Sierra ORCID Department of Mechanical Engineering, National Technology of Mexico in Celaya (TecNM), Celaya 38010, Mexico; Department of Chemistry, University of Guanajuato, Guanajuato 36050, Mexico
J. Santos García-Miranda Department of Mechanical Engineering, National Technology of Mexico in Celaya (TecNM), Celaya 38010, Mexico
Karla J. Moreno ORCID Department of Mechanical Engineering, National Technology of Mexico in Celaya (TecNM), Celaya 38010, Mexico

Resumen

AISI 4140 steel is still one of the most distinguished steels employed in tribological applications because of its low cost, great mechanical properties, and appropriate wear resistance. In this contribution, the tribological performance of AISI 4140 annealed steel against engineering ceramic was analyzed to promote parameters for the application of this steel, especially in systems that are subjected to contact pressures between 490–1240 MPa. Dry and lubricated pin-on-disk experiments were completed at different normal loads. The worn surfaces were analyzed by contact profilometry, optical and scanning electron microscopies, energy dispersive spectroscopy, and microhardness examinations. In dry conditions, a better friction response was found on the steel tested with ZrO2. Friction coefficient and wear rate resulted in reductions up to 60% and 99% compared with those obtained with Al2O3 and Si3N4 counterparts. A strain-hardening phenomenon due to the friction process was observed on the samples tested with ZrO2 and Si3N4, which showed grain refinement and hardness increment on worn surfaces. Therefore, those systems exhibited better wear responses. In lubricated conditions, all counterparts exhibited low friction and wear, but the performance of Al2O3 and Si3N4 was highlighted. The results demonstrate that the performance of AISI 4140 annealed steel under the tested conditions is comparable with that of the same steel with other surface treatments.

Datos de publicación

Cita esta publicación

Comprueba el estilo que requiere tu institución o revista.

Luis D. Aguilera-Camacho; María T. Hernández-Sierra; J. Santos García-Miranda; Karla J. Moreno. (2021). On the Influence of Tribological Properties of AISI 4140 Annealed Steel against Ceramic Counterparts under Dry and Lubricated Conditions and Their Effect on Steel Microstructure. Metals, 11(8), 1275. https://doi.org/10.3390/met11081275

Fuentes y trazabilidad

Se conserva la procedencia de los datos y se da prioridad a la revista cuando existe información editorial.

Licencias declaradas por las fuentes

https://creativecommons.org/licenses/by/4.0/

Descargar ficha bibliográfica

El PDF contiene los metadatos y el enlace al trabajo original.