DESARROLLO DE DISPOSITIVO DE FLEXIÓN PARA MÁQUINA UNIVERSAL ZWICK Z050 (DEVELOPMENT OF FLEXION TEST DEVICE FOR ZWICK Z050 UNIVERSAL MACHINE)
Pistas Educativas
Resumen
ResumenEl laboratorio del área de Mecatrónica cuenta con una máquina universal Zwick Z050 en la cual se pueden realizar ensayos de compresión, tensión y flexión aplicando cargas desde 1 N hasta 50 kN, sin embargo, no se contaba con dispositivos para pruebas de flexión, por lo que el proyecto se basó en elaborar un herramental para usar dicha función de la máquina.Debido a la alta demanda de pruebas en polímeros se definieron las dimensiones tanto del dispositivo como de las probetas bajo los parámetros de la norma ISO 178.Se generaron propuestas de diseño mediante un establecimiento de funciones; la selección de alternativas se realizó por medio del criterio de índices ponderados en los cuales se abarcó el tipo de material, su resistencia, el costo y su manufactura, así como la selección del diseño del herramental.El diseño del dispositivo consta de 15 piezas. Algunas de ellas fueron fabricadas con acero 4140T debido a que soportan la carga aplicada, mientras que las piezas restantes se fabricaron de acero 1018 por soportar una demanda de carga inferior.Palabras clave: dispositivo, ensayos, flexión, norma, probeta. AbstractThe laboratory of the Mechatronics area has a Zwick Z050 universal machine in which compression, tension and bending tests can be performed applying loads from 1N to 50kN, however, there were no devices for bending tests, so the project was based on making a tooling to use this function of the machine.Due to the high demand for tests on polymers, the dimensions of both the device and the specimens were defined under the parameters of the ISO 178 standard.Design proposals were generated through a set of functions; the selection of alternatives was made through the criterion of weighted indexes in which the type of material, its resistance, cost and its manufacture were covered and thus the design of the tooling was selected.The bending device was designed in 15 pieces. Some parts were manufactured from 4140T steel because they bear the applied load, while the remaining pieces were made from 1018 steel for supporting a lower load demand.Keywords: bending, device, standard, tests, test tube.
Datos de publicación
Cita esta publicación
Comprueba el estilo que requiere tu institución o revista.
Fuentes y trazabilidad
Se conserva la procedencia de los datos y se da prioridad a la revista cuando existe información editorial.
Licencias declaradas por las fuentes
Licencia en el registro de origen