Instituto Tecnológico de Celaya Tecnológico Nacional de México
ITC Investigación ITC
Explorar publicaciones
Artículo · 2011 · Catálogo consolidado

Stationary state error reduction on the electrical modelling of high pressure sodium lamps

IET Electric Power Applications

R. Osorio Electronics Department, Universidad Autonóma Metropolitana (UAM), Distrito Federal, 02200, México
N. Vázquez Electronics Department, Universidad Autonóma Metropolitana (UAM), Distrito Federal, 02200, México
S. Pinto Electronics Engineering Department, Instituto Tecnológico de Celaya, Celaya, 38010, México
G. Martínez Electronics Engineering Department, Instituto Tecnológico de Celaya, Celaya, 38010, México
M. Ponce Electronics Engineering Department, Centro Nacional de Investigación y Desarrollo Tecnológico (CENIDET), Cuernavaca, 62490, México
A. Padilla Electronics Department, Universidad Autonóma Metropolitana (UAM), Distrito Federal, 02200, México
J. Prado Electronics Department, Universidad Autonóma Metropolitana (UAM), Distrito Federal, 02200, México

Resumen

This study presents an improvement in the steady-state error reduction in the electrical modelling of high pressure sodium (HPS) lamps when they exhibit high non-linear behaviour. An electrical expression of the lamp is resistance could be obtained from the Saha equation, which is sufficient to represent the behaviour of several high intensity discharge lamps with low non-linear behaviour, but if the modelled lamp possess high non-linear operation, as do some HPS lamps, a large stationary error between the simulation and experimental results is obtained. Therefore an enhanced expression of lamp resistance is proposed here to reduce this error. Parameters are obtained from the measurements of electrical variables such as power, current and voltage, in the lamp. The proposal can be used to simulate the non-resonant ballast. Experimental and simulation results are shown.

Datos de publicación

Cita esta publicación

Comprueba el estilo que requiere tu institución o revista.

R. Osorio; N. Vázquez; S. Pinto; G. Martínez; M. Ponce; A. Padilla; J. Prado. (2011). Stationary state error reduction on the electrical modelling of high pressure sodium lamps. IET Electric Power Applications, 5(4), 350-358. https://doi.org/10.1049/iet-epa.2010.0194

Fuentes y trazabilidad

Se conserva la procedencia de los datos y se da prioridad a la revista cuando existe información editorial.

Descargar ficha bibliográfica

El PDF contiene los metadatos y el enlace al trabajo original.